Connecting the chandeliers and light fixtures

As a general rule in the junction box has a hook on which hangs a chandelier or lamp. Hook screwed into the plastic box. Over time, plastic loses its strength and the chandelier might fall. Therefore, before you hang a chandelier best prosverdlit new hole in the junction box so that the plug went into the ceiling, tentatively place to avoid falling into the wires, and twist it into a hook. In the junction box can be a lot of wires. We need to find only three: zero and two-phase wire after the switch, if the double switch. And one phase after the switch if the switch is single. Turn the switch - one key. We put a screwdriver on the expected indicator wire. Indicator lit screwdriver, live wire from the switch is found. Turn off the switch. Again put the screwdriver on the indicator the same wire. The indicator is not lit screwdriver. Repeat steps two times to make sure that the wire is found correctly. Likewise, look for the second phase conductor from the second key. Now we are looking for a zero (blue wire, black or white). Put the indicator screwdriver on the expected zero. The indicator is not lit screwdriver. This is a zero. And it found zero or one and two-phase wires in the junction box, which come after the switch. Turn off the power. We hang a chandelier or lamp on the hook. In Chandeliers, lamps, there are three wires. All wires are different colors. Zero (black, white or blue). We connect him to the neutral wire in the junction box. Two-phase wires connect to two chandeliers phase conductors in the junction box. Sometimes there is a fourth wire - Xanthophta color is grounded. If the same is in the junction box - connect them together. All wires are connected with each other using chandeliers Clem. To connect the chandeliers and lamps need a tool. If the ceiling must be drilled should choose a place to drill is that it did not get the directions to the switches and wires in the adjacent room (the builders of our great magicians). Pay attention to the distribution box of wires (there are on the ceiling). In any case, centimeter by 4.3 you can safely go. The second point - do not forget to cut the top electricity. Just in case. A third point. As a rule, new homes, the top layer of loose ceiling tiles, which can not be said about the deeper layers. Therefore, to make havoc ceiling entirely, use a good punch, which you the first time all done. Also, if you scared go, lead the 2 pins (plugs) in the ceiling, and between them throw the jumper. The load is distributed between them. And yet. Builders are rarely what they do not at right angles. Ie wires are likely to lie completely in certain ways. Generally, there are special priborchiki to determine the hidden wiring: any wires on which the current flows, creating crosstalk. Older receivers their well-notch, if bring closer. The light should be turned on.