Defects in upholstery work

There are gaps between the banners. This means that when pasting butt ill add on the edge of the wallpaper. Before pasting wallpaper should check for shrinkage and only then decide: cut edges of dry or wetted wallpaper. It is best to trim the edges after Wallcovering with a sharp knife to fugovannoy lineup. Ragged edges on wallpaper arise from careless trimming, use a blunt instrument, careless storage of prepared for sticker wallpaper, rolled into a roll. Correction is possible through the plywood. Cloth wallpapers are crooked. This may be because the label is first webs made "by eye", without skips a vertical line with plumb. Fix possible only by plywood. Full or partial peeling wallpaper on top of walls. Probably wallpaper pasted on surfaces previously painted limestone or glue paints that were not schischeny. It is also possible that the surfaces were not taped, or apply a liquid paste, or were badly missed wallpaper, or while working in the room was hot. Correct the defect as follows. Desktop untuck and purified from the sticky paint (whitewash). Removed from the walls of Nabeul, not to leave a trace. Well-glued surface of a thick paste and smear them as wallpaper, giving them a good opportunity to soften. They were then glued and carefully smooth, but always through the paper, so as not smeared paint. Desktop behind a door trims and baseboards. In these places were badly glued surface, as wallpaper or have been plastered with a liquid adhesive composition, or after buttering long cemented. Desktop untuck well promazyvayut adhesive composition in one or two times until the wallpaper does not soften. Then they stick with careful priglazhivaniem through the paper. Thread visible seams. This happens because the edge of wallpaper is not directed against the light, ie, the pasting was conducted not by the window, and vice versa. Correction is possible only through the plywood. Edge of the wallpaper paste are filled, which eclipsed the wallpaper. This happens if the label was carried out with hot paste, which quickly softens the paper and gets to the front surface. Possibly on the edge has been applied too much glue, and when he squeezed priglazhivanii. In addition, the wallpaper can be made of thin paper, it is easy leaky. Correction is possible hanging new wallpaper with cool or warm glue with temperature above 30 ° C. Cloth wallpaper of various shades. Hence they are not picked up by the tone. This requires a plywood. When trimming rolls past it was necessary to inspect and select. Solid stick to the walls, not forced by furniture and is well lit during the day. Bubbles and wrinkles on the wallpaper may arise from the use of too strong an adhesive composition for wallpaper made of thin paper, negligent priglazhivaniya, and also because wallpaper badly soaked with paste. Correction is possible through the plywood wall-paper. Wallpaper in the corners of the walls are broken. When buttering the adhesive composition wallpaper paper softens and enlarges the length and width, it dries, it gives greater shrinkage, which leads to the rupture of the wallpaper, when the angle was closed in one piece. Plywood at an angle to overlap the edge of the wallpaper width not more than 30-50 mm