Dry building mixtures

Smooth wall surfaces can be decorative, causing plaster sprayed, Rustam, etc. On the wooden walls, it can be made of conventional lime-gypsum mortars, the stone and the like - from the lime-gypsum, cement and cement-lime solutions. Texture sprayed done throwing the solution through a mesh strjahivaniem solution with a broom or with a brush. Sprayed through the mesh with a broom perform any solution (even with large aggregates), sprayed with a brush - a solution with a fine filler. To get a tight sprayed without permits, it is repeated several times until the surface is not coated with a solution will not seats. Sprayed over the net. On a wooden frame the size of 1000x1000 or 1000x1500 mm pull a grid with mesh size from 2,5 to 10 mm (depending on the size texture). That the grid does not buckle and vibrate, with the reverse side of the frame on the diagonal pull on the wire, which carries the net, tying it to the wire in two or three places. To frame has always defended the same distance from the surface, her nail bar - rack length 100-250 mm. Constant position relative to the frame plastered surface makes it possible to get sprayed the same size, but it should throw a solution with equal force. Frame puts the damage to the surface of the soil and a trowel with a falcon throw over the net solution. Passing through the grid, the solution is cut and falls to the surface in the form of tubercles. Sprayed with a broom perform well. Take a birch broom without leaves, chop off the ends. Right hand holding a broom, and left - a round, fairly heavy, stick with a diameter of 4-5 cm, 50-60 cm long broom dipped in a solution and hit them on a stick. The solution was shaken on the surface of the wall. Coarseness of such invoice depends on the thickness of a broom twigs, density and strength of shaking off the solution. Therefore, if both are running multiple people need to pick up all the same broom, same size sticks, agree on the strength of shaking off and on the distance from the surface, which should be a stick. During operation, the solution is stirred periodically, so that it does not separate. Sprayed from a brush allows you to get a finer texture than the grid or with a broom. The solution should be protsezhen through a fine sieve with a mesh no larger than 1,5 x1, 5 mm. Work hard to take the hair or bristle brush. She kept his left hand and dipped into the solution at half the height of the hair, brings to the surface of the hair up. Then hold the hair being in the right hand with a stick or a thin plate, and the solution from a brush flies off on a plastered surface. Formed a dense fine-grained texture, called the finish "under the coat." Composing the texture consists of small or large stones, gravel and crushed stone. Gravel or crushed stone sorted by sifting through a sieve with a mesh size. The sorted material was washed with water to remove dirt. On the surface scratch coat solution is applied and the soil, level it and then the solution vtaplivayut gravel or crushed stone at half or one third of its height. Then prepare a solution of a creamy consistency and apply it with a trowel hawk layer no thicker than 5-10 mm. In this case, the solution can be arbitrary. In addition to trowel mortar can be applied by spraying through a grid, with a broom or with a brush. Solutions can be normal with subsequent painting or colored, painted with dry ink by acids in the whole mass.